Made of high grade chrome moly tubing, these MIG welded arms offer lighter than stock weight while delivering superior strength over stock or reinforced VW trailing arms



MANUFACTURER DIRECT PRICES

3" X 3" REAR TRAILING ARMS (With Bolt-in Aluminum Bearing Carriers)

• Light weight Chromoly tubing (approx. 12lbs. each).

• Much stronger than stock or "box" type trailing arms.

• Available with Type I bearing carrier.

• Accepts up to 930 CVs.

• Will work on any torsion housing that will accept a stock trailing arm.

$450.00 / Set
single shock mounting kit = $40.00 ($80.00 installed)

4" X 5" DUAL PIVOT REAR TRAILING ARMS

• All chromoly tubing – lighter and stronger than “boxed” arms

• 4” wider and 5” longer than stock – allows 17” plus of wheel travel

• Complete arm with Rod End and Load Boss weighs approx. 19 lbs.

• Available for either Type I or Micro-stubs (same price for either bearing carrier)

• Will bolt in any torsion housing that will accept a Type I trailing arm*

*Stock Type I IRS shock tower needs to be removed

$780.00/set
single shock mounting kit = $50.00 ($100.00 installed)

SHOCK MOUNTS
available in kit form or installed
Mounts shown installed on 4" X 5" Rear Trailing Arm

TOP LEFT PHOTO: 3 x 3 Rear trailing arms shown on Eagle 4-Play frame with VW engine and Type II Bus trans-axle. Car shown has 12” of rear travel using torsion bars and Type II cv’s. Using 3x3 rear arms with 930 cv’s and coil-over suspension allows up to 15” wheel travel. Rear tire width is 84” using standard buggy off-set rear wheels (2” back spacing) and 13.00 tires.



INTRODUCTION

EXTENDED FRONT TRAILING ARMS

LONG TRAVEL FRONT BEAM

COIL-OVER CONVERSION KIT

CONTACT EAGLE PERFORMANCE